What the Indicators function does
Turn this function on and the Nexus can drive the turn signal (indicator) lights itself. It's aimed at builds where the factory body electronics have been removed, such as race cars, restomods with new wiring, or vehicles controlled by a Nexus VCU.
Output Mode
- Constant: the output stays on while the signal is active. Use this when something else, like an existing flasher relay, does the flashing.
- Pulsing: the Nexus flashes the lights itself at a 50% duty cycle. The Flash Period setting, in milliseconds, sets how long each flash cycle takes.
If you're using pulsing mode, remove or bypass any old flasher relay in the circuit. Two things trying to flash the same bulbs gives you an erratic blink.
Hazard Lights
Enable this and you can assign an input, typically a dash switch, that flashes all the indicators together as hazard lights.
Showing it on a dash
The Nexus shares indicator status over CAN with Haltech displays like the iC-7, so the dash can show what the lights are doing without extra wiring.
For the physical connections, see indicator wiring, and for the other lighting outputs, headlight wiring.
