Rywire K20C1 Master Engine Connector Kit - K20C1 Swap Harness Build (K20C1-Connector-Kit)

Rywire K20C1-Connector-Kit is a master connector kit for the turbocharged, direct-injection Honda K20C1, for building a K20C1 swap engine harness. It covers the direct-injection injectors and pump, both VTC solenoids, drive-by-wire throttle body, wastegate actuator and boost pressure plugs. This connector kit is meant for building your own engine harness from scratch or re-terminating a tucked harness. Every connector comes with its housing, terminals, seals and terminal locks.

What's Included

• 4 coil connectors
• 4 direct-injection injector connectors
• 1 VTEC solenoid connector
• 1 VTEC oil pressure switch connector
• 1 intake VTC solenoid connector
• 1 exhaust VTC solenoid connector
• 1 alternator connector
• 1 drive-by-wire throttle body connector
• 1 knock sensor connector
• 1 coolant temperature connector
• 1 intake cam sensor connector
• 1 exhaust cam sensor connector
• 1 crank sensor connector
• 1 manifold pressure/temperature connector
• 1 oil pressure connector
• 1 starter solenoid connector
• 1 wastegate actuator connector
• 1 boost pressure (pre-throttle) connector
• 1 direct-injection pump connector
• 1 oil level connector

Not Included (Order Separately If Needed)

• Flex fuel (ethanol content) sensor connector
• Purge control solenoid connector

Fitment

• Honda K20C1 engine plugs
• Building or repairing a K20C1 swap engine harness

Wire is not included. Crimp tooling is required.