Rywire Drive-By-Wire Universal Harness Kit - Any Standalone Engine Harness (DBW-SUB-Universal)

Rywire DBW-SUB-Universal is a two-piece drive-by-wire harness kit for any standalone engine harness and standalone computer. One sub-harness runs from a Bosch (Porsche GT3) 68 mm or 82 mm throttle body to the computer; the other runs from the Rywire DBW pedal to the computer. Use it to add electronic throttle to an engine swap that was not built with it.

Engine Swap Fitment

• Any standalone engine harness running a standalone computer
• Bosch (Porsche GT3) 68 mm or 82 mm drive-by-wire throttle body
• Rywire Drive By Wire Pedal Kit (Yazaki 6-pin pedal connector); other pedals can be specified in the order notes

Connector List

• Throttle body sub-harness: Bosch (Porsche GT3) throttle body to computer
• Pedal sub-harness: Yazaki 6-pin pedal connector to computer

What's Included

• Throttle body sub-harness
• Pedal sub-harness

Frequently Asked Questions

Should I order it with my engine harness?

Yes, ideally. Some changes may be needed on the computer side of the harness, and Rywire can install and adjust them when it is ordered with the engine harness.

I am not using the Rywire pedal. Can it still work?

Yes. Tell us your pedal in the order notes so Rywire builds the correct connector. Email service@tunedbyshawn.com with your engine, chassis and ECU before ordering if you are unsure which configuration you need.

For off-road and competition use only. Not legal for use on pollution-controlled motor vehicles.