Rywire 6-Switch Mil-Spec Switch Panel - Ignition, Starter and Pump/Fan Control (RY-SWITCH-6)

Rywire RY-SWITCH-6 is a six-position switch panel for race cars and stripped swap builds: ignition, starter and four on/off circuits in one aluminum bezel. It is built with Tefzel wire and Raychem DR-25 heat shrink and terminates in a single 12-pin DTM connector, made to plug into the Rywire Race Fuse/Relay Box V3.

Vehicle Fitment

• Universal panel
• Plug and play with the Rywire Mil-Spec Universal Race Fuse/Relay Box V3
• With a different fuse box you may need Rywire's mating Deutsch connector

Features

• Six water-resistant 20A 12V rocker switches
• 1 master/ignition switch (red), high-side activated
• 1 momentary starter switch, low-side activated
• 4 on/off switches: 3 low-side and 1 high-side activated, for pumps or motors
• Low-side switches rated up to 8A; high-side switch rated up to 20A
• Aluminum bezel, 7 3/4 in wide x 2 1/2 in tall
• Tefzel wire and Raychem DR-25 heat shrink
• 12-pin DTM connector

Recommended Add-Ons

• Rywire Sticker Sheet - Switch Panel & Race Fuse/Relay Box.
• Rywire Mil-Spec Universal Race Fuse/Relay Box V3 - For B/D/H-Series Engine Harnesses.

Add any of these from the Recommended Add-Ons list above. Each one is its own listing.

What's Included

• Six-switch panel with harness and 12-pin DTM connector
• Mating connector when the panel is purchased on its own

Frequently Asked Questions

Will it work with a fuse box other than the Rywire V3?

Yes, but you may need the mating Deutsch connector to wire it to a different fuse box.

What can the on/off switches control?

They are configured to switch pumps or motors. The three low-side switches handle up to 8A and the high-side switch up to 20A. Email service@tunedbyshawn.com with your engine, chassis and ECU before ordering if you are unsure which configuration you need.