Injector Dynamics 15mm Bottom O-Ring (92.16)

Small parts are what stand between a sealed fuel system and a fuel leak.

Every injector install lives or dies on its seals and seats. The Injector Dynamics 15mm Bottom O-Ring (92.16) is the correct service part for the applications listed below, sized to seat Injector Dynamics injectors properly. Fresh seals on every install is cheap insurance. Do it once, do it right.

What You'll Feel

• Injectors seat with the correct installed height and preload
• No fuel smell in the garage after the install
• No vacuum leaks or weeping o-rings to diagnose later
• Reinstalls and rail-off maintenance without reusing tired seals

Features

• Correct fitment for the Injector Dynamics configurations listed below
• Sold individually unless noted

The Details

O-rings, cushions, washers, and adapters are the parts that set injector height and keep fuel where it belongs. Reusing compressed seals is the most common cause of post-install leaks and vacuum draw at the injector bores, so replace them any time the rail comes off. Match the part to your injector configuration using the part number, and if you are unsure which seal your setup takes, ask before ordering.

Kit Includes

• 1 - O-Ring

Applications

• 15mm o-ring for bottom of ID injector