What this table sets
When Throttle Blip is enabled in Flat Shift, the Nexus can briefly open an electronic throttle during a shift to match revs. This table sets the throttle position, as a percentage, that the throttle is commanded to during a blip. The throttle goes to that position and stays there for the blip unless one of the exit conditions ends it early. The table can be mapped in up to 3D, so the blip size can change with things like gear or RPM.
How long the throttle stays open is set in Throttle Blip Duration. The two work together: amount sets how far, duration sets how long.
What to check
- Start with small openings and short durations, then increase until the revs match the next gear cleanly.
- Lower gears usually need bigger blips because the RPM change between gears is larger.
- Log engine speed through each shift. Revs flaring past the target means too much, a jerk on engagement means too little.
Need this diagram? Ask us and we'll send it over with advice for your build.
