What it's for
An electronically shifted automatic doesn't have one wire per gear. It has a handful of shift solenoids, and each gear is selected by a specific combination of them being on or off. Outputs for Gear is the table that tells the Nexus which transmission control outputs to switch on in each gear position.
You'll find the solenoid pattern for most transmissions in the factory workshop manual, and sometimes in the owner's manual. It's usually shown as a grid of gears against solenoids marked on or off. Enter that pattern here, gear by gear.
When you won't see it
If you've picked a preconfigured transmission from the Transmission Type dropdown in the Transmission settings, the solenoid states for each gear are already built in. NSP hides this setting in that case, because there's nothing to change.
Tips
- Double-check that each output in this table matches the physical solenoid it's wired to. See transmission control wiring.
- Test each gear with the vehicle safely supported before a road test.
- If a gear is wrong, compare this table with the manual's solenoid pattern and with how each output is actually wired before you change either.
Next, set up auto mode shift points and shift duration. Everything else is in transmission control.
