{"product_id":"id1300-xds-fuel-injectors-single-injector-60mm-14mm-adapter-top-14mm-bottom-adapter-1300-60-14-14b","title":"Injector Dynamics ID1300-XDS Fuel Injectors | Single Injector | 60mm, 14mm Adapter Top, 14mm Bottom Adapter (1300.60.14.14B)","description":"\u003cp\u003e\u003cstrong\u003eDuty cycle pegged at 95 percent is not a tune, it is a warning.\u003c\/strong\u003e\u003c\/p\u003e \u003cp\u003eA factory fuel system that was sized for stock power runs out of injector long before a built engine runs out of airflow. The \u003cstrong\u003eID1300-XDS\u003c\/strong\u003e answers that with 1335cc\/min of flow at 3.0 bar, compatibility with all known fuels, built for E85, delivered as a single injector in the 60mm body, 14mm adapter top, 14mm bottom adapter configuration. It is backed by full characterization data, so your ECU gets real numbers, not estimates. This is what consistent fueling actually looks like.\u003c\/p\u003e \u003ch3\u003eWhat You'll Feel\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003eFuel trims that stay put season to season instead of drifting with the weather\u003c\/li\u003e\n\u003cli\u003eStock-like idle and clean cold starts, even at this injector size\u003c\/li\u003e\n\u003cli\u003eHeadroom to grow the build without touching the fuel system again\u003c\/li\u003e\n\u003cli\u003eSteady AFRs when boost climbs, no lean spikes at the top of the pull\u003c\/li\u003e\n\u003cli\u003eFaster dyno sessions, because accurate injector data means less time chasing fuel trims\u003c\/li\u003e\n\u003c\/ul\u003e \u003ch3\u003eFeatures\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003eNominal flow rate: 1335cc\/min at 3.0 bar (43.5 psi), measured with iso-octane at 52 degrees C (125 degrees F)\u003c\/li\u003e\n\u003cli\u003eMaximum differential fuel pressure: 7.0 bar (101.5 psi)\u003c\/li\u003e\n\u003cli\u003eCompatible with all known fuels and designed specifically for alternative fuels like E85\u003c\/li\u003e\n\u003cli\u003eAll stainless internals stand up to the corrosive nature of alcohol fuels\u003c\/li\u003e\n\u003cli\u003eUSCAR electrical connector\u003c\/li\u003e\n\u003cli\u003eConfiguration: 60mm body, 14mm adapter top, 14mm bottom adapter\u003c\/li\u003e\n\u003cli\u003eSold individually, so you can replace one injector or build a set for an uncommon cylinder count\u003c\/li\u003e\n\u003c\/ul\u003e \u003ch3\u003eThe Details\u003c\/h3\u003e\u003cp\u003eThe ID1300-XDS was designed in partnership with Bosch Motorsport with alternative fuels in mind, and its stainless internals shrug off the corrosive side of alcohol better than anything else in this flow class. It was also built with the occasional switch back to gasoline in mind, with a minimum fuel mass low enough to idle and cruise cleanly on pump gas. Injector Dynamics publishes  full characterization data, including slope, offset (dead time) versus voltage and pressure, and short pulse width behavior, so your tuner can load real numbers instead of chasing fuel trims across the map. Accurate dead times are what make large injectors behave at idle and cruise, and they are the reason these tune quickly and stay tuned. This configuration uses machined top adapters (already fitted) to suit the rail height listed above. A machined bottom adapter (already fitted) extends the injector to suit a 14mm manifold bore at the stock depth. If your harness does not have USCAR plugs, plug and play connector adapters are available separately, no cutting or soldering required.\u003c\/p\u003e \u003ch3\u003eFitment Notes\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003eUSCAR Connector, 60mm length, 14 mm (grey) adapter top and (silver) bottom adapter.\u003c\/li\u003e\n\u003c\/ul\u003e \u003ch3\u003eKit Includes\u003c\/h3\u003e\u003cul\u003e\u003cli\u003e1 - ID1300-XDS Fuel Injector\u003c\/li\u003e\u003c\/ul\u003e \u003ch3\u003eApplications\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003eUniversal: 60mm body, 14mm adapter top, 14mm bottom adapter, USCAR connector\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Injector Dynamics","offers":[{"title":"Default Title","offer_id":67645637656643,"sku":"1300.60.14.14B","price":265.65,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0064\/7754\/5539\/files\/id1300-xds-1300-60-14-14b.jpg?v=1791383638","url":"https:\/\/www.tunedbyshawn.com\/products\/id1300-xds-fuel-injectors-single-injector-60mm-14mm-adapter-top-14mm-bottom-adapter-1300-60-14-14b","provider":"Tuned by Shawn","version":"1.0","type":"link"}